Flotec sump pump float switch repair
|
|
Tether Float Switch Cast-Iron Submersible Effluent Pump EFL30 Features: -Cast-iron submersible effluent pump.-Piggy-back tether float switch for automatic or manual operation.-2” NPT discharge capable of handling 0.75” solids.-Designed for easy installation without any plumbing changes.-Stainless steel ring for portability.-Upper ball bearings for quiet operation.-Engine HP: 1/3.-Pumps up to 3900 GPH @ 0′.-Phase: Single-phase. Specifications: -Volta… |
|
|
Superior Pump 91250 1/4 HP Thermoplastic Submersible Utility Pump $51.16 1/4 HP split capacitor motor – high efficiency – Low amp draw, 10′ grounded waterproof power cord, pumps up to 30 gallons per minute, 1800 gallons per hour, side and bottom intake provides for clog resistant suction, cooler operating 115V motor provides continuous duty, pump will lift water over 25 ft. vertical height, 1-1/4″ male iron pipe discharge thread, standard hose adapter included. One yea… |
|
|
Little Giant VCMA-15ULS 554405 VCMA Series Automatic Condensate Removal Pump (115 volts), 1/50 horsepower $29.81 The company that has always been the forerunner in condensate removal pump design, introduces the new generation VCMA Series. Adding features for every installation. Fully Automatic, new generation float arm for enhanced reliability. Suitable for high-efficiency, gas-furnace condensate. 3 drain holes with 20ft. shut off head and 8.7 PSI. Capable of drawing 50 GPH @ 5ft.. Intermittent Liquid Temp. … |
|
|
Little Giant 554425 VCMA-20ULS Condensate Removal 1/30 HP Pump with Safety Switch $36.11 Little Giant VCMA-20ULS… |
|
|
Johnson Pumps Of America 36303 Marine 20 Amp Ultima Auto Bilge Control Switch $31.71 Ultima SwitchNew digital technology uses the Mirus field effect detector cells producing micro-electrical fields that detect disruptions caused by water and fluids. Detector cells are totally sealed, are never in contact with the water, will not corrode and are not affected by oil or foreign debris.ULTIMA activates at a 50 mm (2″) fluid level and deactivates at a 20 mm (3/4″) fluid level. A 3 seco… |
|
|
Refrigerant Recovery Cylinder Tank 30Lb. Description: 30 lb.Dot Class: 4BA4003/4″ NPT Plug: YESFloat Switch: NOWater Cap.: 26.2 lbs.Tare Wt.: 17 lbs. Standard shipping rate only applies to the lower 48 states and does not include Alaska and Hawaii. Please contact us for shipping rates to these locations…. |
|
|
Johnson Pumps Of America 36152 Marine Electronic Float Switch $16.21 Mayfair Electronic Float Switch. Stay safe and afloat with the Mayfair Electronic Float Switch! Automatically engages your newer-model Mayfair and Johnson L-series bilge pumps to begin pumping upon detecting water. Includes wiring / installation instructions. Order yours today! Mayfair Electronic Float Switch… |
|
|
Tripp Lite APS2012 2000W 12V DC to AC Inverter with Automatic Line-to-Battery 100/25-Amp Charger $1,089.00 Tripp Lite APS2012 PWRINV APS 2012 2000W 12VDC HWIRE… |
|
|
Stainless Steel Liquid Level Wired Float Sensor Switch $12.97 Float Ball Material: Plastic; Float Body Material: Plastic; Retaining Clip Diameter: 15mm/ 0.6″; Body Total Length: 130mm/ 5.1″; Cable Length: 350mm/ 13.8″; Color: Silver Tone, Black, Red; Weight: 67g; Package Content: 1 x Water Level Sensor; A float switch is a device used to sense the level of liquid within a tank. The switch may actuate a pump, an indicator, an alarm, or other device; |
|
|
Water Draining Service Float Switch Fluid Level Controller 250v $24.36 Come with a manual for easy to install; Wet cellars, automatically filling a pond when evaporation or leaks have reduced the water level.Automatically filling header tanks.Etc; As the water rises, at a pre determined level the switch turns on the pump.Once the level has been reduced to the level you set Automatically turns On and Off , Adjustable switching level, Plugged models are simple to insta… |
|
|
1.5 1/3 HP TSW Submersible Sump Systems $322.99 LGP1071: The TSW Submersible Sump Pump is an innovative alternative to the traditional submersible sump pumps. This pump features a solid state IntelliSwitch automatic switch and alarm circuit that eliminates the potential hang ups seen with float switches. The alarm portion of the circuitry is built into the IntelliPlug power cord plug. It has an audible alarm and a red warning light to indicate a high water condition in the sump. The IntelliPlug also has a green run light to show the pump is operating. Features: -Includes pump, 22 basin, clear view cover assembly and discharge kit with clear check valve -Pump is UL and CSA certified -Center discharge (1-1/2 NPT) for suspended installation from sump basin cover, to keep pump off the bottom where gravel or other debris are more likely to cause clogging that may result in a flooded basement -Integral IntelliSwitch with no moving parts for the most reliable automatic turn-on and turn-off operation, a high water alarm activation that reduces the potential for mechanical switch malfunction or failure that may result in a flooded basement -Integral IntelliPlug that provides a red, high water alarm light and 85 db buzzer, a push-to silence switch and a green run light to show when pump is running -Bottom screened inlet and a recessed, vortex impeller to reduce the potential for clogging that may result in a flooded basement -Both upper and lower ball bearings for smooth, quiet operation and longer motor life -Mechanical shaft seal provides protection against water entry into the motor -All exposed component parts of the pump are made of corrosion – resistant materials to provide a longer service life -Environmental friendliness in mind: Powerful and efficient 1/3 HP permanent split capacitor motor draws less than 5.0 full load amps, conserving energy while delivering 40 GPM at 10′ total dynamic head Specifications: -PSI: 14.3 -HP: 2 -Hz: 60 -Volts: 115 -GPM at 5′ of Head: 45 -Discharge Port: 1.5 TSW Series Sp |
|
|
Big Combination Sump Pump System $388.97 BSW1004: Features: -Pump system.-Package contains: Controller, charger, two dual micro reed float switches, primary pump and backup pump, instruction manual (battery and acid sold separately).-Material: Acrylonitrile butadiene styrene.-Offers two combination sump pump systems designed to provide both primary and battery backup pump capabilities.-Primary pump will operate as long as it is receiving AC power.-Power is interrupted, or if more water is coming into the sump than the AC pump can handle, the backup sump pump will begin pumping automatically.-Backup system has unique monitoring features that diagnose a problem and sound an alarm.-Light on the display panel of the control unit will indicate the cause of the alarm and the corrective action.-Two systems have been pre-assembled for easy installation.-Compact, fits in pits as small as 12” in diameter.-Dual float switches for added protection.-Primary float switch has a protective cage.-Engine HP: 0.5 (Primary) and 0.33 (Backup).-Primary system pumping capacity: 4400 GPH @ 0′ or 3200 GPH @ 10′.-Backup system pumping capacity: 2500 GPH @ 0′ or 1730 GPH @ 10′. Color/Finish: -Color: Silver and Black. Specifications: -Power supply requirements: 115 volts AC. Dimensions: -Dimensions: 18” H x 11” W x 8.75” D. Warranty: -2-Year warranty. Disclaimer: -User-friendly controller sounds an alarm, illuminates a warning light and describes what to do for easy maintenance. |
|
|
Combination Sump Pump System $319.99 BSW1003: Features: -Pump system.-Package contains: Controller, charger, two dual micro reed float switches, primary pump and backup pump, instruction manual (battery and acid sold separately).-Material: Acrylonitrile butadiene styrene.-Offers two combination sump pump systems designed to provide both primary and battery backup pump capabilities.-Primary pump will operate as long as it is receiving AC power.-Power is interrupted, or if more water is coming into the sump than the AC pump can handle, the backup sump pump will begin pumping automatically.-Backup system has unique monitoring features that diagnose a problem and sound an alarm.-Light on the display panel of the control unit will indicate the cause of the alarm and the corrective action.-Two systems have been pre-assembled for easy installation.-Compact, fits in pits as small as 12” in diameter.-Primary float switch has a protective cage.-Engine HP: 0.33 (Primary) and 0.25 (Backup).-Primary system pumping capacity: 3600 GPH @ 0′ or 2600 GPH @ 10′.-Backup system pumping capacity: 2000 GPH @ 0′ or 1000 GPH @ 10′. Color/Finish: -Color: Silver and Yellow. Specifications: -Power supply requirements: 115 Volts AC. Dimensions: -Dimensions: 17.75” H x 10” W x 8.75” D. Warranty: -2-Year warranty. Disclaimer: -User-friendly controller sounds an alarm, illuminates a warning light and describes what to do for easy maintenance. |
|
|
Johnson Pump 2 Way Bilge Control – 12V $25.56 2 Way Bilge Pump ControlSwitch panel that gives full control of your equipment. Just push the button for manual or automatic bilge pumping. The automatic feature operates in combination with the automatic bilge switches or the electronic float switch. The three-position switch panel in matte black finish has an integrated fuse holder and operating light. Fuses included. Size: 73 mm/2.99 x60 mm/2.17 , 40 mm/ 1.57 depth.Specifications:Volts: 12 |
|
|
Rule ECO-Switch Automatic Bilge Pump Switch $37.07 ECO-SwitchThe Rule ECO-Switch is an ecologically sound automatic bilge pump control control switch. Featuring a non-mercury design, the pump operates with simple air pressure. As water rises in the bilge, air rises in the air tube that is attached to switch. This air pressure activates the switch which controls your pump. There are no moving internal parts, all wiring is out of the water, and there are no submerged electrical connections at all. Offering complete reliability and outstanding performance, the Rule ECO-Switch offers a viable alternative to traditional float switches.Specifications:Volts: 12v |
